Pamela Cole Harris of Home and Garden Makeover.com, invites you to reprint this
article in your print publication, ezine, or on your website.
This is a Free-Reprint article. The only requirements for publishing this article
are:
You must leave the article and resource box unedited.
Minor editing to the
article is permitted, only for the purpose of correcting any
overlooked spelling or grammar problems. You are not allowed
to change our recommendations, nor are you allowed to change
the context of the article.
You may not use this article in UCE (Unsolicited Commercial Email).
Email distribution of this article MUST be opt-in email only.
You must forward a copy of the ezine or newsletter that contains the
article inside to the author at:
pacole3@homeandgardenmakeover.com.
If you post this article on a website, you MUST set any URL's
in the body of the article and most especially in the Author's
Resource Box as hyperlinks. You must also send us a copy of
the URL where you have posted this article.
If you find any of the rules to be unsavory or unacceptable, please
do not publish this article. While we are happy to make the content
available to you for your own use, we must insist on having our rules
and *Terms of Reprint* honored in full.
Thank you for adhering to these four very simple rules.
So you got the perfect refrigerator. For the perfect kitchen.
Miles and miles of virgin stainless steel. Perfect width. A
virtual soda fountain in the door. And as your husband (just a
shade less than perfect) pulls it across the floor to that
perfect spot wayyyyy on the other side of the kitchen, you hear a
slight ripping sound. Can stainless steel rip? Not likely. Your
husband gives it another pull. The same sound. Looking down to
investigate (as any perfect homeowner would), you discover that
your perfect vinyl flooring now has a wide, perfectly-jagged
tear. Yikes!
Here is how you can make the perfect repair:
1. Measure the extent of the damage. Width? Length?
2. Is your vinyl flooring relatively new? You should be able to
find the pattern at your local home-improvement or flooring
supply store. If your pattern is unavailable, you may have to
replace the entire floor.
3. Buy enough of the flooring to repair the damaged area and a
little extra to save for future repairs.
4. Cut a piece of the new flooring a bit larger than the damaged
area. A sharp utility knife should do the job (handle with
care!). Use a straight edge or ruler to help keep the blade
vertical.
5. Match the pattern of the new piece with the old at each edge
of the damaged area.
6. Take out your handy dandy duct or masking tape and tape the
new piece to the floor below. You don't want the new tile to
slip, so make certain you have taped it securely.
7. Ok. This is tricky. Use your knife to cut through both layers
of vinyl. Cut around the damaged area (make certain you cut it
just a bit bigger so that you will remove all the damage).
8. Now remove the new vinyl on top and the piece of damaged vinyl
beneath. If you have difficulty removing the old vinyl, a hair
dryer works great to soften the adhesive!
9. Scrap away all of the old gunk (Gunk. That's a technical
term!) with a putty knife or an old mismatched table knife
(not a steak knife!). Be sure to sweep clean!
10. Using your putty knife, apply adhesive to the back of the new
piece of vinyl. Make sure your kitchen is well-ventilated.
That stuff can be harmful!
11. Press the new piece into place. It's best to start at the
center and work towards the edge to make certain all those
little air bubbles are worked out.
12. If you have excess adhesive around the edges, wipe it up with
a clean, damp sponge.
13. This is the fun part! Take your rolling pin (you DO have a
rolling pin, don't you?) and roll the patch firmly. You will
have to wipe the excess adhesive again.
14. Now you can let the adhesive dry (no dancing on it for about
24 hours!).
Zowie! Now your perfect kitchen has returned! Wait! Is that a
perfectly awful footprint I see?
Pamela Cole Harris is an editor and writer with 35 years
experience. Visit her website,
http://www.homeandgardenmakeover.com, for a free newsletter
with remodeling, home improvement and decorating ideas for the
financially challenged, creatively deficient and technologically
illiterate.
This article was originally written: January, 2004
More Articles Written by Pamela Cole Harris Notice: The Phantom Writers
played no part in creating this content. Our client has purchased our
thePhantomWriters Distribution Services, and we have distributed
this article to over 6,000 publishers and webmasters. As part of this
service, we offer this page and the Copy-and-Paste version of this article
on autoresponder.
Stand out from the crowds. Educate your prospects and they will turn to you for more knowledge. When they turn to you for more, they will visit your website. It is up to your website copy to sell your products, NOT your article. Provide great information and at your website, address how the prospect will benefit from what you are offering. Using these things in conjuction will help your cash register to ring.
